Reading 1820 Blogs Daily!


  • journeys
  • Page 1 of 1 ( posts )
July 5, 2021
Journeys Month 10 – Victory Block: Part 1 from If These Threads Could Talk

Welcome to Stitchin Heaven’s Journeys BOM – Month 10 Victory Block: Part 1. This month you will be using Studio 180 Design V Block tool. Sarah Furrer is my helper this month.

Unit P, V Blocks will be cut from Print 1 & Print 4.

Piecing Instructions

Step 1 – Cut the Center Triangles from Print 4 strips. Lay the strip out and fold over the end of the strip as shown. Position the V Block® tool on the strip so that the Fold Line for Center Triangle is on the fold and the bottom of the strip ...

read more
December 7, 2020
Journeys Month 3 – Flying Geese from If These Threads Could Talk

Welcome to Stitchin Heaven’s Journeys BOM Month 3. This month you will be learning to make flying geese the Deb Tucker way, using your Wing Clipper I. My helper this month is Deb Tucker herself! As always use your best cutting, stitching and pressing skills. We will be using prints 1, 2 & 5. Carefully cut your starter squares and let’s go!

Prints 1, 2 & 5

Piecing Instructions Flying Geese Construction

Step 1 – Mark Squares. Begin with one large Print 1 square and two Print 2 and two Print 5 small squares. On the wrong side of each small ...

read more
October 6, 2020
Journeys Month 1 – Uneven Chains from If These Threads Could Talk

Hi everyone and welcome to Stitchin Heaven’s “Journeys” Block of the Month (BOM).  I will be here to guide you through each month’s process, but not without some help from my friends.  I was asked to participate in this BOM back in May.  I had already tested the pattern design by Deb Tucker.  In June I was diagnosed with breast cancer.  I am so blessed to have friends that are helping me.  They are each taking a month and creating the units and taking photo’s as they go.  They are sending the photo’s to me so ...

read more
  • journeys
  • Page 1 of 1 ( 3 posts )